BAY AREA AIR QUALITY
MANAGEMENT DISTRICT |
Source Category
| Source: | Polyester Resin Operations - Hand and Spray Layup | Revision: | 2 |
| Document #: | 129.2.1 | ||
| Class: | All | Date: | 9/27/06 |
Determination
POLLUTANT |
BACT 1. Technologically Feasible/ Cost Effective 2. Achieved in Practice |
TYPICAL TECHNOLOGY |
| POC | 1. Enclosure of
operation and vent to an afterburner (>0.3 sec. retention time at >1400oF) or an activated carbon adsorption system (<6
ppm at outlet)b,c 2. Compliance w/ BAAQMD Reg. 8, Rule 50, use of polyester resin material with a monomer content of no greater than 34 percent by weight and use of aqueous emulsion cleaner or acetone for clean-up to maximum extent possibled |
1. BAAQMD Approved
Design and Operationb 2. BAAQMD Approved Design and Operationd |
| NOx | 1. n/a 2. n/a |
1. n/a 2. n/a |
| SO2 | 1. n/a 2. n/a |
1. n/a 2. n/a |
| CO | 1. n/a 2. n/a |
1. n/a 2. n/a |
| PM10 | 1. Enclosure of
operation and vent to an afterburner (>0.3 sec. retention time at >1400oF) b,c 2. Airless spray equipment and spray booth w/ mesh type filtersb |
1. BAAQMD Approved
Design and Operationb 2. BAAQMD Approved Design and Operationb |
| NPOC | 1. n/d 2. n/d |
1. n/d 2. n/d |
References
| b. BAAQMD c. Afterburner not appropriate with halogenated hydrocarbons d. BAAQMD Permit Application #12563 |